Click image to view full size image
Rubber mixing mill
Version: Xk-160 xk-230 xk-250 xk-300 xk-360 xk-400 xk-450 xk-560
1. General advantage
1.1. Automatic temperature and time controlsystem
1.2. High Mixing Performance
1.3. Uncompromising quality
1.4. Easy installation
2. Application:
The mill is used for rubber plasticating, mixing, warming and sheeting.
3. General design:
3.1. The mill consists mainly for rolls, frame, bearing, roll nip adjusting, screw, heating and cooling device, emergency stop, lubrication system and such sections as electrical controls and, etc.
3.2. The main electric motor arrives the front and rear rolls to rotate oppositely through reduar, driving geras and friction gears.
4. Features:
4.1. The rolls are made of chilled alloyed castiron. Their working surfaces are of high hardness and wear-resistant. The working temperature of the bored roll is controllable by steam, cooling water or oil that pass through them thus, to meet the requirements of milling process.
4.2. Roll nip adjustment is realized by hand or electricity which can obtain high accuracy and sensitivity.
Version: Xk-160 xk-230 xk-250 xk-300 xk-360 xk-400 xk-450 xk-560
1. General advantage
1.1. Automatic temperature and time controlsystem
1.2. High Mixing Performance
1.3. Uncompromising quality
1.4. Easy installation
2. Application:
The mill is used for rubber plasticating, mixing, warming and sheeting.
3. General design:
3.1. The mill consists mainly for rolls, frame, bearing, roll nip adjusting, screw, heating and cooling device, emergency stop, lubrication system and such sections as electrical controls and, etc.
3.2. The main electric motor arrives the front and rear rolls to rotate oppositely through reduar, driving geras and friction gears.
4. Features:
4.1. The rolls are made of chilled alloyed castiron. Their working surfaces are of high hardness and wear-resistant. The working temperature of the bored roll is controllable by steam, cooling water or oil that pass through them thus, to meet the requirements of milling process.
4.2. Roll nip adjustment is realized by hand or electricity which can obtain high accuracy and sensitivity.
| Parameters | Version | ||||
| XK-160 | XK-250 | XK-400 | XK-450 | XK-560 | |
| Roll diameter (mm) | 160 | 250 | 400 | 450 | 560 |
| Roll length(mm) | 320 | 620 | 1000 | 1200 | 1530 |
| Front roll surface speed(m/min) | 8.89 | 15.3 | 18.65 | 24.32 | 27.72 |
| Friction ratio | 1:1.35 | 1:1.1 | 1:1.27 | 1:1.27 | 1:1.2 |
| Max. nip | 4 | 8 | 10 | 15 | 15 |
| Feeding capacity per time | 1-2 | 10-15 | 18-35 | 25-50 | 35-50 |
| Power(km) | 5.5 | 18.5 | 37 | 55 | 90 |
| Size(length*width*height) | 1160*920*1370 | 3120*1322*1500 | 4350*1850*1780 | 5670*2390*1670 | 5845*2284*1978 |
| Weight(T) | 1000 | 4000 | 7600 | 12000 | 23000 |